firmware v1.2 backporting (1.0 and 1.1 hardware versions.)

[caitsith2]

I have backported the firmware for version 1.2 hardware over to version 1.0 and 1.1 hardware.

http://BANNED.com/projects/tvbg_v1.2 ... 20v1.0.zip

Usage: To switch region/loop setting, hold the button while inserting the batteries. This will be acknowledged with the number of flashes.

2 = NA region set (World wide firmware.)
3 = EU region set (World wide firmware.)
4 = Loop Disabled (Region specific firmware.)
5 = Loop Enabled (Region specific firmware.)

If you don't hold the button while inserting the batteries, then you will get one of the 4 flash codes above. If however, on inserting the batteries, you only get one blink, check your batteries.

http://BANNED.com/projects/tvbg_v1.2 ... 20v1.1.zip

Usage: To switch region/loop settings, Insert the batteries. If it blinks only once, hit the reset button once. At this point, it should blink 5 times. During this 5 blinks, you have the opportunity to hit the reset button again. If you do, then the settings will be changed, and the above code list blinked accordingly.

http://BANNED.com/projects/tvbg_v1.2 ... 20v1.2.zip

Usage: Settings is a matter of soldering in the region resistor. (Stock firmware.)

[dlemmink]

Looks like the code is no longer on your site. Any chance you can re-post it?

[Agent24]

You could upload to the forum?

[caitsith2]

Links fixed. I forgot about these, at the time of my hosting provider crash quite some time ago. There are probably other links still to be fixed, that I am not sure of.

[Agent24]

Links fixed. I forgot about these, at the time of my hosting provider crash quite some time ago. There are probably other links still to be fixed, that I am not sure of.

That's true, I came across some links to projects on your site recently, but they are all gone. Your projects folder only contains the TV-B-Gone firmware and not the other stuff (will post the links I found, if you want to know what they were)