Assembled kit doesn't work
I've just built my TVBgone 1.2 from the kit and it doesn't work.
The led test didn't work either.
I've attached photos of both sides, the soldering is pretty clean and I don't know what could be wrong.
I didn't put the switch and LEDs all the way in because I want to move them in a custom case, but they are fixed and soldered.
By the way, I wanted to replace the switch with another off(on) switch and read it could just be connected through two holes for the switch, the ones closer to the "+" of the batteries, is this correct?
Thanks in advance for your advices.
- IMG_4502.JPG (169.31 KiB) Viewed 2122 times
- IMG_4501.JPG (161.76 KiB) Viewed 2122 times