Can The MiniPOV3 be used with Atmega 16

For Adafruit customers who seek help with microcontrollers

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
mohd
 
Posts: 2
Joined: Tue Jun 11, 2013 5:21 am

Can The MiniPOV3 be used with Atmega 16

Post by mohd »

Image

Guys, im wondering .. plz help me.. i see here the MiniPOV3 programmer can be used just with ATTiny, but...

Q1: Can i use " The MiniPOV3 uses the serial "DASA" circuit " programmer with ATmega (8,16 and 32) without any problems?????????
======================================================
Q2: i found that DASA pins can be interfaced the ATTiny2313 uC with the PC, such as :
DASA
RESET = RTS
SCK = DTR
MOSI = TXD
MISO = CTS

But, when i was reading the ATTiny 2313 datasheet, i doesn`t find the pin "SCK"....
Where is it ????!!!!!
======================================================
Q3: plz can you show me the usb/serial converter that i must use it with the above circuit...
======================================================
Q4: Can i used a Ponyprog2000 to burn the hex code????
======================================================

Locked
Please be positive and constructive with your questions and comments.

Return to “Microcontrollers”