Hi,
I've just received and started with Teensy 3.0 received this week from Adafruit. After some initial setup (soldering header, Arduino IDE) and some testing, Teensy blinks as expected. I then felt ready to go little bit further and tried connecting string a 4 NeoPixel (breadboard kit from Adafruit). I loaded the strandtest from NeoPxel library and successfully loaded to Teensy. It works for about 5mn and then blackout... Teensy no longer answer to upload, reset, unplug-plug. I tested power pins and expected 5v and 3.3v are present on board pins... but Teensy looks dead.
Any idea on how to get closer to problem isolation? Did I get a bad Teensy board?
Thanks,
Yanick.
Dead Teensy 3.0 after 5mn of usage?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88089
- Joined: Sat Feb 07, 2009 10:11 am
Re: Dead Teensy 3.0 after 5mn of usage?
Any signs of life at all? LED activity?
Post a photo showing your soldering on the board.
Post a photo showing your soldering on the board.
-
- Posts: 2
- Joined: Sat Nov 16, 2013 9:49 pm
Re: Dead Teensy 3.0 after 5mn of usage?
Here it is...
Yet no sign of life.
Thanks,
Yet no sign of life.
Thanks,
- Attachments
-
- Teensy3.0
- teensy3-0_small2.jpg (234.29 KiB) Viewed 1837 times
- adafruit_support_bill
- Posts: 88089
- Joined: Sat Feb 07, 2009 10:11 am
Re: Dead Teensy 3.0 after 5mn of usage?
If you contact [email protected] with a link to this thread we can send you a replacement.
Please be positive and constructive with your questions and comments.