I hope I'm submitting this request for help in the correct place.
I recently purchased and setup this shield with my Uno. I used this http://learn.adafruit.com/adafruit-cc30 ... y-software link as a guide. After set up there is a 'buildtest' sketch to test the hardware out. I ran this and the sketch prints jiberish on the serial monitor. Can anyone give me some pointers on where to look for the problem.
cc3000 generates jiberish on serial screen
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- Franklin97355
- Posts: 23911
- Joined: Mon Apr 21, 2008 2:33 pm
Re: cc3000 generates jiberish on serial screen
Is your serial terminal and the program talking the same baud rate?
-
- Posts: 14
- Joined: Thu Jan 30, 2014 11:30 pm
Re: cc3000 generates jiberish on serial screen
That was it! Thanks for the quick response!
Please be positive and constructive with your questions and comments.