So im utterly confused. I understand you can't toss a 3.3 or less i2c device on a 5v buss.. Per ADA's Page "If you want to use this sensor with a datalogger that uses the DS1307, remove any/all of the pullup resistors from the DS1307 SDA/SCL pins. " Per the Schematic thats R1 & R2 of the Data-Logger Shield. I pulled those parts off the board and looked at the line with my scope, Its still high at 5v. Am i missing something?
http://www.ladyada.net/make/logshield/design.html
http://learn.adafruit.com/tsl2561/wiring
TSL2561 and ADA Datalogger Shield
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 12151
- Joined: Thu Apr 06, 2006 4:21 pm
Re: TSL2561 and ADA Datalogger Shield
there is a very weak internal pullup, its not dangerous, continue the project
- twilliamson
- Posts: 22
- Joined: Tue Dec 20, 2011 10:06 am
Re: TSL2561 and ADA Datalogger Shield
No Smoke and I was able to communicate with it... Thanks... Might could note that somewhere to "idiot" proof it more...
Please be positive and constructive with your questions and comments.