Hello there,
I need to make 4 AC motors controll 110/220 V also need to findout each motor consumption motor size is 4 amp at the max, please advice which shield or design can be sufficient, I also want to put water level reader based on ultra sound or tank deeper then 3 meters or other type of measurement's please advice what arduino to use?
Regards,
Labib
Motor Shild
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88093
- Joined: Sat Feb 07, 2009 10:11 am
Re: Motor Shild
For AC motors you would need a relay circuit. The PowerSwitchTail contains a relay and an interface to drive from an Arduino: http://www.adafruit.com/products/268
For measuring water levels, the Maxbotix Weather Resistant sensor would be the best choice: http://www.adafruit.com/products/1137
Any Arduino can control these devices. An UNO is a good choice: https://www.adafruit.com/products/50
For measuring water levels, the Maxbotix Weather Resistant sensor would be the best choice: http://www.adafruit.com/products/1137
Any Arduino can control these devices. An UNO is a good choice: https://www.adafruit.com/products/50
Please be positive and constructive with your questions and comments.