Coil-gun Project
Moderators: adafruit_support_bill, adafruit

Coil-gun Project

by Ruvim on Thu May 02, 2013 11:59 pm

Hello,
I am new to arduino and am building a coil-gun for my last quarters physics class. I am building a multistage coil-gun and have run into a problem. Check out this site to so that you'll know kinda what I'm taking about: http://www.youtube.com/watch?v=mdZo_keUoEs I am hooking up photo interrupters to an arduino and need to hook up a couple of capacitors to run the current through the coils while being able to have the arduino turn on and off the current running through the coils. My problem is that I'm using super capacitors (Maxwell 350Farads) and I need to hook them up so I could control there flow with the arduino without frying the arduino or anybody else. Any tips/suggestions would be much appreciated. I heard of ESC (Electronic Speed Control) but not sure if there strong enough.
Ruvim
 
Posts: 1
Joined: Mon Apr 08, 2013 1:23 am

Re: Coil-gun Project

by adafruit_support_mike on Fri May 03, 2013 9:29 pm

Generally speaking, it sounds like you want to control the capacitors with mosfet switches, but an exact solution will depend on the voltage you're using, the size of the caps, the peak current you want the coils to achieve, coil size and spacing, etc.

I'd suggest you talk to your physics professor or TA to work through the details. At very least, they should be able to point you to some references on the subject.
When you void a product warranty, you give up your right to sue the manufacturer if something goes wrong and accept full responsibility for whatever happens next. And then you truly own the product.
User avatar
adafruit_support_mike
 
Posts: 9140
Joined: Thu Feb 11, 2010 1:51 pm