Ethernet Shield Interrupts
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- tlerdrden
- Posts: 80
- Joined: Fri Nov 30, 2012 4:46 pm
Re: Ethernet Shield Interrupts
lesson learned! I've tried to do the circuit as you tell but, no the interrupts are not detected!! However, i can see using the voltmeter that the voltage measured between the Capacitor terminals goes down when I push the button as I want... What's happening?
- Attachments
-
- Voltage measured between the capacitor terminals while pushing the button
- foto 2.JPG (140.96 KiB) Viewed 195 times
-
- Voltage measured between the capacitor terminals before pushing the button
- foto 1.JPG (143.75 KiB) Viewed 195 times
- adafruit_support_bill
- Posts: 88152
- Joined: Sat Feb 07, 2009 10:11 am
Re: Ethernet Shield Interrupts
Not sure what circuit you refer to. I did not recommend one. I generally use a software solution. If you disable interrupts for 5-10ms after a button press, you will usually eliminate the 'bounce'.I've tried to do the circuit as you tell but, no the interrupts are not detected!!
- tlerdrden
- Posts: 80
- Joined: Fri Nov 30, 2012 4:46 pm
Re: Ethernet Shield Interrupts
Done! Thanks a lot Adafruit!
Please be positive and constructive with your questions and comments.