What is the best way to connect Temperature Probe right to the Arduino Uno Board. The user manual says the following:
//Connect the BLACK lead to GND
//Connect the RED lead to pin 2
//Connect the WHITE lead to pin A0
But the wires pop out from the board, see picture showing wire ends.
Temp Probe
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- marck1
- Posts: 66
- Joined: Fri Mar 14, 2014 12:47 pm
Temp Probe
- Attachments
-
- Wire Leads
- image1.PNG (90.02 KiB) Viewed 171 times
- Franklin97355
- Posts: 23910
- Joined: Mon Apr 21, 2008 2:33 pm
Re: Temp Probe
You can solder 22ga solid wire to the ends and use that in the headers. Don't forget the 4.7K resistor.
Please be positive and constructive with your questions and comments.