Sanguino and WaveShield

[anxion]

Hello,
Did you know if the WaveShield is fully compatible with the Sanguino mapping ?
I need the Sanguino because my 328P haven't enough ram to launch my program and the WaveHC in the same time.
FreeRam test said -650 bytes ..

[adafruit]

someone may have 'ported' it to the sanguino but otherwise, no we have not done it ourselves

[fat16lib]

The pin mapping is not defined for the Sanguino in WaveHC.

ArduinoPins.h checks for a Sanguino but only generates an error since the pins are not defined.

You could define a pin map and try the Wave Shield on the Sanguino. The SPI pins for the Sanguino are :

# Digital 4 - SS (used for SPI)
# Digital 5 - MOSI (used for SPI)
# Digital 6 - MISO (used for SPI)
# DIgital 7 - SCK (used for SPI)

You need to define three or four pins for the DAC. You only need three if you ground LAT.

[anxion]

Ok thanks, I've received my Sanguino this morning, I'm gonna try this and give you a report.

http://www.atmel.com/dyn/resources/prod ... /8011S.pdf

The SPI pins aren't 4, 5, 6, 7 instead of 5 ,6, 7, 8 ?

[fat16lib]

The Sanguino spi pins should be 4, 5, 6, 7. I corrected the above error.

[anxion]

I've modified ArduinoPins.h and WavePinDefs.h
The WaveShield works great on both board
If we are running on ATmega128, 328, 1280 it use Arduino pins 2, 3, 4, 5 for DAC and if it's ATmega644P it use Sanguino pins 0, 1, 2, 3

[fat16lib]

Thank you. I will include your Sanguino mods in a future release of WaveHC.

[Bratan]

Wow, works like a charm! Thank you so much anxion!
fat15lib, Please include it the future library