Hi,
I have managed to set up the arduino ad wave shield to loop audio based on the example on the ladyada site,
I also have a separate sketch receiving sensor values however, I am unable to combine them.
Ideally i would like the flexiforce sensor to trigger the arduino when it receives a reading of > 1000
any help will be much appreciated!
Wave Shield, Arduino + Flexiforce Sensor
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88096
- Joined: Sat Feb 07, 2009 10:11 am
Re: Wave Shield, Arduino + Flexiforce Sensor
Start with one of the push-button examples. Then replace the digitalRead with an analogRead and a compare against 1000 instead of digital HIGH.
Please be positive and constructive with your questions and comments.