Hello, I am new here.
I have been struggling getting data from an EM-406a and was wondering if it is me, or do I have a bad EM-406a.
The Setup:
USB FTDI TTL-232 cable connecting my PC with the GPS shield which is fitted with an EM-406a.
Using a terminal emulator, I am able to connect to the EM-406a and recieve data from it.
The troulbe is, it takes about 30 minutes to see any satalites are report co-ordinates.
Once it sees some satalites, all is better.
I was hoping for a faster startup time than this.
The datasheets says 42 second Cold Start.
I suspect the long startup time is due me relying on my window (from inside)???
If I power down the unit, wait five minutes, and power it up, it starts reporting co-ordinates almost immediately.
If I power down the unit over night (about 8 hours), it takes a great deal of time to start reporting co-ordinates.
How long can the EM-406a be powered off befor it has trouble working?
Any help? What should I expect?
-dusty
EM-406a startup time
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88093
- Joined: Sat Feb 07, 2009 10:11 am
Re: EM-406a startup time
That can certainly be a factor. It will have an easier time acquiring satellite signals with a clear view of the open sky.I suspect the long startup time is due me relying on my window (from inside)???
Please be positive and constructive with your questions and comments.