Adafruit Motor/Stepper/Servo Shield
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 2
- Joined: Thu Dec 08, 2011 2:32 pm
Adafruit Motor/Stepper/Servo Shield
When I use this Adafruit Motor/Stepper/Servo Shield on a Arduino Uno, can I still use the 3V3, 5V and GND pins of my Arduino ?
- adafruit_support_bill
- Posts: 88155
- Joined: Sat Feb 07, 2009 10:11 am
Re: Adafruit Motor/Stepper/Servo Shield
Yes. They will be easier to access if you build the shield using stacking headers instead of the standard headers.
-
- Posts: 2
- Joined: Thu Dec 08, 2011 2:32 pm
Re: Adafruit Motor/Stepper/Servo Shield
Ok, thank you, I asked this, because i didn't see 3V3 on the shield http://www.flickr.com/photos/ladyada/22 ... 8/sizes/l/
- adafruit_support_bill
- Posts: 88155
- Joined: Sat Feb 07, 2009 10:11 am
Re: Adafruit Motor/Stepper/Servo Shield
The pin is there - right next to the 5v. pin. But there is no breakout hole for it. The stacking headers will bring it out as a female header socket - just like on the Arduino.
Please be positive and constructive with your questions and comments.