I just assembled my Motor Shield V1.2 and the Servo1 and Servo2 (and corresponding S1 and S2) labels are wrong.
On my board Servo1's signal trace goes to pin 10 and Servo2's signal trace goes to pin 9.
Also, the polarity of C7 and C8 caps are silk screened with the negative side toward the analog pins. In the older boards, at least in the photos on the "Build It" link, the polarity of those caps shows the positive side toward the analog pins.
I am looking for a little sanity check on these issues. Someone at Adafruit here who can chime in?
Much thanks!
Motor Shield V1.2 Servo 1 and 2 labeled wrong?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 12151
- Joined: Thu Apr 06, 2006 4:21 pm
Re: Motor Shield V1.2 Servo 1 and 2 labeled wrong?
there's been some silkscreen changes. as for servos, just swap the 9 and 10 pins!
Please be positive and constructive with your questions and comments.