I'm curious if it's possible to read/write a single eeprom address on a MiFare classic 1k card, instead of an entire "block" using the Adafruit NFCShield I2C library?
Hardware setup as follows
Arduino Uno R3
Adafruit PN532 NFC/RFID Controller Shield for Arduino
MiFare Classic (13.56MHz RFID/NFC) Bracelet - 1KB
Mifare read/write question
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 12151
- Joined: Thu Apr 06, 2006 4:21 pm
Re: Mifare read/write question
you can check the PN532 datasheet for details - but in general EEPROMs are written block by block
Please be positive and constructive with your questions and comments.