Reset button not working on LCD shield

[stefan.wiswedel]

Hey all,

SO, I have the 16x2 standard LCD shield (http://www.adafruit.com/products/772) and it all works beautifully except for the reset button. I am using it in 'detached' mode at the moment but it didn't work while attached either.

Any ideas?

SW

[adafruit_support_bill]

If you post photos of the front & back of the board, we'll check things out. For the reset to work detached you would need run a wire for the reset pin in addition to power and I2C. But if it doesn't work attached either, something is amiss...

[Pascal74]

Good evening,

I have the same problem with the reset button

My shield as you ask




Thanks for your help
PJ

[adafruit_support_bill]

You only have 4 wires there. For the reset to work you need to connect the reset pin too.

[Pascal74]

Thanks for your answer.
Where shall i find the label for the pins ?

And how to connect the reset button to my Arduino Uno ?

Regards

[adafruit_support_bill]

Find the pin labeled "RESET" on your UNO (It is right next to the 3.3v pin). Connect that to the corresponding pin on the shield.