Hi guys,
I mistakenly ordered the RFID Shield instead of the breakout board, and after plenty of research it seems fairly difficult to hook up.
Can you lend any assistance?
Regards,
Danny
RFID Shield with Raspberry Pi
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_rick
- Posts: 35092
- Joined: Tue Mar 15, 2011 11:42 am
Re: RFID Shield with Raspberry Pi
Actually, it shouldn't be all that difficult to hook up, but I believe you would need a level-shifter for the I2C lines, since I don't think the Shield has any jumper points where you can access 3.3V signals.
However, if you contact [email protected] with a link to this thread, we'll be happy to exchange the shield for the breakout board.
If you decide to stick with the shield, post back here and we'll talk about hooking it up
However, if you contact [email protected] with a link to this thread, we'll be happy to exchange the shield for the breakout board.
If you decide to stick with the shield, post back here and we'll talk about hooking it up
Please be positive and constructive with your questions and comments.