Motor shield V2 plus Ethernet shield trouble

Adafruit Ethernet, Motor, Proto, Wave, Datalogger, GPS Shields - etc!

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
derekpdx
 
Posts: 14
Joined: Tue Jan 29, 2013 11:26 am

Motor shield V2 plus Ethernet shield trouble

Post by derekpdx »

I'm having trouble when stacking the ethernet shield (official arduino model) with the Adafruit motorshield V2. It will not connect at all, not even the example codes included with the IDE. Once i remove the motorshield it works fine. I'm not using a servo, so I know i dont have to worry about the conflict on pin 10 so I'm not sure wthere the problem originates. Any ideas?

User avatar
adafruit_support_bill
 
Posts: 88093
Joined: Sat Feb 07, 2009 10:11 am

Re: Motor shield V2 plus Ethernet shield trouble

Post by adafruit_support_bill »

Do you have the 2x6 stacking header for the ICSP pins installed? The shield gets it SPI signals from the ICSP header.

derekpdx
 
Posts: 14
Joined: Tue Jan 29, 2013 11:26 am

Re: Motor shield V2 plus Ethernet shield trouble

Post by derekpdx »

Oh, nope. I did not have that soldered. Just installed it, now it works perfect! Thanks!

Locked
Please be positive and constructive with your questions and comments.

Return to “Arduino Shields from Adafruit”