Audrino micro and Motorshield V2

Adafruit Ethernet, Motor, Proto, Wave, Datalogger, GPS Shields - etc!

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
jerseysal
 
Posts: 1
Joined: Sat Apr 05, 2014 5:31 am

Audrino micro and Motorshield V2

Post by jerseysal »

I am trying to figure out what pins on the Audrino Micro need to be connected where on an Adafruit Motor shield. Any joy???

User avatar
garyvdg
 
Posts: 91
Joined: Thu Jul 25, 2013 12:37 pm

Re: Audrino micro and Motorshield V2

Post by garyvdg »

jerseysal wrote:I am trying to figure out what pins on the Audrino Micro need to be connected where on an Adafruit Motor shield. Any joy???
Check out the Arduino Micro site at:
http://arduino.cc/en/Main/ArduinoBoardMicro

It will tell you to use Pins 2 and 3 for I2C communication to the motor shield.

User avatar
adafruit_support_bill
 
Posts: 88088
Joined: Sat Feb 07, 2009 10:11 am

Re: Audrino micro and Motorshield V2

Post by adafruit_support_bill »

Pin 2 is SDA and pin 3 is SCL. And of course you will also need +5v and GND.
For motor power, you can also connect VIN and install the VIN jumper. But for most applications, it is better to power the motors via the external power terminals on the motor shield.

Locked
Please be positive and constructive with your questions and comments.

Return to “Arduino Shields from Adafruit”