Audrino micro and Motorshield V2
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- jerseysal
- Posts: 1
- Joined: Sat Apr 05, 2014 5:31 am
Audrino micro and Motorshield V2
I am trying to figure out what pins on the Audrino Micro need to be connected where on an Adafruit Motor shield. Any joy???
- garyvdg
- Posts: 91
- Joined: Thu Jul 25, 2013 12:37 pm
Re: Audrino micro and Motorshield V2
Check out the Arduino Micro site at:jerseysal wrote:I am trying to figure out what pins on the Audrino Micro need to be connected where on an Adafruit Motor shield. Any joy???
http://arduino.cc/en/Main/ArduinoBoardMicro
It will tell you to use Pins 2 and 3 for I2C communication to the motor shield.
- adafruit_support_bill
- Posts: 88093
- Joined: Sat Feb 07, 2009 10:11 am
Re: Audrino micro and Motorshield V2
Pin 2 is SDA and pin 3 is SCL. And of course you will also need +5v and GND.
For motor power, you can also connect VIN and install the VIN jumper. But for most applications, it is better to power the motors via the external power terminals on the motor shield.
For motor power, you can also connect VIN and install the VIN jumper. But for most applications, it is better to power the motors via the external power terminals on the motor shield.
Please be positive and constructive with your questions and comments.