Hello,
Just bought this shield. When loading the logger tutorial sketch into arduino the enviroment shows the following message:
avrdude: stk500_getsync(): not in sync: resp=0x32
I am using Windows 7 with arduino enviroment 1.0.5-r2 and Arduino uno R3.
I have formatted the SD card with SD card utility.
Any idea what is going on?
Thanks!
Datalogger Error: avrdude: stk500_getsync(): not in sync: re
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- robergc
- Posts: 13
- Joined: Mon Mar 17, 2014 6:44 pm
- jigsawnz
- Posts: 180
- Joined: Mon Mar 12, 2012 10:17 pm
Re: Datalogger Error: avrdude: stk500_getsync(): not in sync
Do you have the Arduino board selected as your target board? check tab, Tools->Board->Arduino Uno.
- robergc
- Posts: 13
- Joined: Mon Mar 17, 2014 6:44 pm
Re: Datalogger Error: avrdude: stk500_getsync(): not in sync
Upps!, I feelreally stupid... I forgot to select arduino uno. Now it works!jigsawnz wrote:Do you have the Arduino board selected as your target board? check tab, Tools->Board->Arduino Uno.
Thanks very much
- abqlewis
- Posts: 71
- Joined: Fri Dec 11, 2009 2:19 am
Re: Datalogger Error: avrdude: stk500_getsync(): not in sync
This happens so much, you would think by now the Arduino IDE wouldn't just print out the error, but say:
avrdude: stk500_getsync(): not in sync: resp=0x32
Oops! Are you sure you selected the correct board?
avrdude: stk500_getsync(): not in sync: resp=0x32
Oops! Are you sure you selected the correct board?
Please be positive and constructive with your questions and comments.