Newbie to arduino and have officially soldered 2 projects, specifically two cc3000 shields this afternoon which leads to my question.
I soldered them fairly well i think ( attached photo ) and they power up no problem but when I try to run the board test they spit back a string at me that gets larger over time making me think the board is trying to interact and having some sort of failure. The string is;
BANNED´BANNEDB"âåO4i¤A
The code I used to test the cc3000 shield is the official adafruit buildtest which I downloaded today. Thanks to everyone who reads and can help.
Shields Power UP But Wont Activate, Need Help
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- Herner
- Posts: 2
- Joined: Sat Aug 09, 2014 1:19 pm
Shields Power UP But Wont Activate, Need Help
- Attachments
-
- IMAG1402[1].jpg (1022.29 KiB) Viewed 141 times
- Franklin97355
- Posts: 23940
- Joined: Mon Apr 21, 2008 2:33 pm
Re: Shields Power UP But Wont Activate, Need Help
Make sure your serial terminal baud rate is set to 115200 or change line 61 in the program.
- Herner
- Posts: 2
- Joined: Sat Aug 09, 2014 1:19 pm
Re: Shields Power UP But Wont Activate, Need Help
I am so pleased to say that your fix worked and that my soldering job worked and all I needed was the correct baud rate :) You made my afternoon.
Please be positive and constructive with your questions and comments.