Fuzebox soldering instructions - few issues
Moderator: adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 6
- Joined: Mon Dec 01, 2008 5:16 pm
Fuzebox soldering instructions - few issues
As I was putting my Fuzebox together today, I noticed few issues with the instructions. C5 is mentioned twice, and there is no mention of C4, C23 or R24. Just figured I would say something
- tim1724
- Posts: 7
- Joined: Mon Dec 08, 2008 5:59 pm
Re: Fuzebox soldering instructions - few issues
I noticed the same problems yesterday when I was assembling mine. I consulted the parts list to verify what the values of the parts not mentioned in the instructions, and it seems to work fine.
I have a leftover resistor (1 kilo-ohm) and an extra capacitor (0.1 microfarad) but I'm 95% sure that they were just extra parts. (My kit had five 1kΩ resistors and thirteen 0.1 µF capacitors, which exceeds what is listed on the parts list.)
I have a leftover resistor (1 kilo-ohm) and an extra capacitor (0.1 microfarad) but I'm 95% sure that they were just extra parts. (My kit had five 1kΩ resistors and thirteen 0.1 µF capacitors, which exceeds what is listed on the parts list.)
-
- Posts: 6
- Joined: Mon Dec 01, 2008 5:16 pm
Re: Fuzebox soldering instructions - few issues
Yep, exactly the same here. Not going to complain about extra parts though
-
- Posts: 12151
- Joined: Thu Apr 06, 2006 4:21 pm
Re: Fuzebox soldering instructions - few issues
the extra .1uF cap is for a 'quality +' hack ill post in a bit
-
- Posts: 1
- Joined: Thu Jan 01, 2009 11:21 am
Re: Fuzebox soldering instructions - few issues
I've seen Ladyada say that C23 was needed for the reset button to work correctly, and that R24 is optional. What is C4 for? Can we get the instructions updated soon?
-
- Posts: 12
- Joined: Thu Dec 25, 2008 6:44 pm
Re: Fuzebox soldering instructions - few issues
Judging from the schematic, I'd say that C4 is necessary for the green channel to be transmitted to the AD725 chip. Without it, I assume that you wouldn't see any green on the screen when using it.
-
- Posts: 31
- Joined: Sat Dec 27, 2008 4:00 pm
Re: Fuzebox soldering instructions - few issues
You must look at the Fuzebox schematic, not the Uzebox's since they are different a bit. On the Fuzebox C4 supposed to part of the power regulator circuit. It is not mandatory but can improve its transient response. Since there's some significant digital switching and power draining when the video rendering starts, I would recommend you put it to get the best possible picture. Also, add the capacitor patch proposed by Forklift and me over here. It *greatly* improves the picture, no kidding!
Cheers,
Uze
Cheers,
Uze
-
- Posts: 12151
- Joined: Thu Apr 06, 2006 4:21 pm
Re: Fuzebox soldering instructions - few issues
Sorry for the delay, I got the flu
The instructions have been updated!
The instructions have been updated!
Please be positive and constructive with your questions and comments.