Hello everyone!
I have two XBEE (series 2) devices and I want connect the first device with a microcontroller (arduino) and the other one on my computer. So I want to control the arduino board from my computer wirelessly. The first device is configured as a coordinator AT (1047) and the second as a Router / End Device AT (1247). These two devices must exchange data in real time (fast).
The problem is that the second Xbee (Router / End Device) cannot read fast the data sent by the computer. This device reads olny 5-6 commands and after that crashes. Must to wait 6-7 seconds to start read again. Instead, the first device(Coordinator) reads and sends all the data in real time.
Does anyone know what could be wrong? I've done something wrong in the regulation of devices?
Thanks!
Problem communication
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88091
- Joined: Sat Feb 07, 2009 10:11 am
Re: Problem communication
Hi, We don't sell or support the Series 2 XBees. You should contact the vendor or try the Digi forums for support.
Please be positive and constructive with your questions and comments.