Hello all, I followed the instructions at http://www.ladyada.net/make/xbee/arduino.html to build a wireless XBee programmer and I've been having a great deal of difficulty making the programmer work. I'm able to do serial debugging, and the reset function works but I've been getting error messages when trying to program the unit:
avrdude: stk500_getsync(): not in sync: resp=0x1e
I've tried using the following baud rates: 56700 (current), 19200, and 115200 [by default the software is programming at this speed over USB so I figured I'd give it a try]. I only seem to get debugging data sent by Serial.println() and related. Does anyone know if there's something different that needs to be done on the Uno R3 to make wireless programming work?
XBee Arduino programmer issues on Arduino Uno REV3
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- joshlucy
- Posts: 4
- Joined: Tue May 29, 2012 2:11 pm
- adafruit_support_bill
- Posts: 88091
- Joined: Sat Feb 07, 2009 10:11 am
Re: XBee Arduino programmer issues on Arduino Uno REV3
So you see the board reset when you start the upload? There should be a few quick flashed from the LED.I'm able to do serial debugging, and the reset function works
Please be positive and constructive with your questions and comments.