I've integrated the Adafruit Xbee adaptor into my own Arduino Mega carrier board, and seem to find that I cannot upload software into the Arduino (via its usb port) unless I remove the Xbee chip from its socket. The only connections I have are RX-TX, TX-RX, 5V to +5V and GND to GND.
Is there anything obvious I might have mis-wired, or ideas of what to look for? I used the same xbee and Arduino with a Libelium adapter previously and I had only the same connections, which makes me fear I may have screwed up something in the adapter circuit during the process of integrating it into my eagle file.
Any thoughts greatly appreciated!
-Mark M.
Xbee-Arduino uploading problem
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 25
- Joined: Thu Dec 31, 2009 8:48 pm
Re: Xbee-Arduino uploading problem
Looks like I just needed to be using one of the secondary tx/rx pairs with the xbee...
Please be positive and constructive with your questions and comments.