Hello,
I just bought an XBee series 1. It's connected using the XBee adapter and FTDI cable. I can configure it using ZTerm, but when it powers off it goes back to the default settings (ID=3332, baud rate=9600). This is the 3rd XBee I've used, so I have some practice configuring and using them, but this one doesn't act like the others. Any suggestions?
XBee won't save configuration changes
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88151
- Joined: Sat Feb 07, 2009 10:11 am
Re: XBee won't save configuration changes
That's unusual. You might ask on the Digi forum. Their tech support is pretty good. If they don't have a solution we'll replace the module.
http://forums.digi.com/support/forum/index
http://forums.digi.com/support/forum/index
- drblythe
- Posts: 9
- Joined: Mon Aug 27, 2012 1:12 pm
Re: XBee won't save configuration changes
Problem was solved by a post on Sparkfun blog - I wasn't issuing ATWR to write configuration after changing it! The new question is why did it work on my other 2 modules because I don't think I used ATWR on those either!
Please be positive and constructive with your questions and comments.