XBee PRO range too short
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 2
- Joined: Sat Jul 27, 2013 10:43 am
XBee PRO range too short
I got two XBee PRO 63mW series 2 modules and when I went out and tested the line of sight range, it was about 800m while it is supposed to have a range of 3200m. I used highest power level with boost mode enabled at 9600 baud. What can I do to increase the range and what does the line of sight range depend on?
- adafruit_support_bill
- Posts: 88090
- Joined: Sat Feb 07, 2009 10:11 am
Re: XBee PRO range too short
The effective range can be affected by a number of factors, including interference from other devices operating in the 2.4GHz band. (phones, Wi-Fi etc.) The folks over at the Digi Forum may have some recommendations to help maximize the range. http://www.digi.com/support/forum/
-
- Posts: 2
- Joined: Sat Jul 27, 2013 10:43 am
Re: XBee PRO range too short
thanks for the quick reply!
Please be positive and constructive with your questions and comments.