Hi, just testing my adapter and it's a little funky. Not communicating with other XBees, red light on just a little, green light not at all. Voltage between G and 3v is measuring 3.87 (no XBEE installed). Any advice? Thanks!
XBEE Adapter Kit 3.87v
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88090
- Joined: Sat Feb 07, 2009 10:11 am
Re: XBEE Adapter Kit 3.87v
The photo is not quite clear, but the solder on the XBee headers looks a little suspicious. If you could take one at a bit of an angle and in better focus, I could see the profile of the joint better.
The 3v. pin should measure 3.3v. Check to make sure that your meter has fresh batteries. Some meters read high when the batteries start to fade.
The 3v. pin should measure 3.3v. Check to make sure that your meter has fresh batteries. Some meters read high when the batteries start to fade.
Please be positive and constructive with your questions and comments.