Hi,
i#m a bit confused about the framework of the xbee protocol. i use two xbees one as a coordinator in api mode on a arduino mega and the others as router in at mode also connected to a arduino. I send data with variable payload. So everything works fine i work with the xbee-api library. But i dont understand the framing in detail even if i compare my output with the frame maker from digi i dont get it right. The offset for my payload dont match with anything i found on the internet. I would need a constant to identify the start of my payload. I analyze a 0x90 Receive Packet in API Mode 2 With a ZigBee device. Dose anybody know a website where i can find a detailed list with all the frame work for the xbee api ?
Thanks in advance.
Xbee API Arduino to Arduino Communication
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88154
- Joined: Sat Feb 07, 2009 10:11 am
Re: Xbee API Arduino to Arduino Communication
Have you asked this question over at the Digi forums? http://www.digi.com/support/forum/
They know the internals best.
They know the internals best.
Please be positive and constructive with your questions and comments.