I built my Monochron this afternoon without a hitch. Decided to replace the firmware with the Intruderchron using my USBtiny programmer and it worked fine.
However, then I tried to revert back to the original firmware and the programmer just seems to power the clock in normal operation, so it won't program (either when set to "power" or "not power" the target board). Anyone been through something similar?
USBtiny powers Monochron while trying to program it...
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 1
- Joined: Fri May 14, 2010 10:46 pm
-
- Posts: 12151
- Joined: Thu Apr 06, 2006 4:21 pm
Re: USBtiny powers Monochron while trying to program it...
power the clock, remove the jumper from the usbtiny
Please be positive and constructive with your questions and comments.