chiragpatnaik wrote:100 Ohm resistor (spare)
chiragpatnaik wrote:100uF Capacitor (spare)
chiragpatnaik wrote:10K Ohm resistor (hope I didn't miss anything).
driverblock wrote:chiragpatnaik wrote:100 Ohm resistor (spare)
You received 2 100Ohm resistors? You did put one into R2, right?chiragpatnaik wrote:100uF Capacitor (spare)
You mean 100nF? You got 4 of these? You did put the other three in C1, C3, C5?chiragpatnaik wrote:10K Ohm resistor (hope I didn't miss anything).
Weird - that's not even on the parts list. You should have got 9 resistors total, plus the pot.
Persistent vertical lines could be caused by a poor connection. If you post clear pictures of the front and back sides of you PCB, we'll have a look.
adafruit_support wrote:You have a stray blob of solder between the capacitor leads as shown below:
It's hard to tell from the top-view, but some of your soldering on the header for the LCD show signs of unsufficient wetting of the pad. Chek the last page of the soldering tutorial referenced by Driverblock for some tips on fixing these.
Users browsing this forum: mibignistinly and 1 guest