Hi,
I recently built the ice tube clock and am pleased with the results aside from one thing. The last digit is very dim, even in the brightest setting. Can you help with this problem. Thanks! daveacnp
Dim second hand digit on bright setting
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88093
- Joined: Sat Feb 07, 2009 10:11 am
Re: Dim second hand digit on bright setting
This is described in the FAQ and is due to the way the tube is driven. There is a drop in voltage from one end of the tube to the other, so the last digit or two often appear dim. Some customers have modified the firmware to compensate for this. http://forums.adafruit.com/viewtopic.php?f=41&t=23586
- jarchie
- Posts: 615
- Joined: Sun Jun 24, 2012 2:16 pm
Re: Dim second hand digit on bright setting
Hi daveacnp. Are you interested in modifying the firmware to make the last digit brighter? If so, I'm sure others on this form (including myself) would be willing to help.
- jarchie
- Posts: 615
- Joined: Sun Jun 24, 2012 2:16 pm
Re: Dim second hand digit on bright setting
Hello again. If the dim digit still bothers you, the cause may be insufficient current running through the tube's filament and not the way the tube is driven. There might also be a straightforward solution: Replace R3 with a jumper. R3 is a bit difficult to remove, as it's squeezed between the alarm switch and VFD chip socket. So instead of removing R3, you could also short out R3 by soldering a jumper across R3 on the bottom side of the board, placing the jumper and R3 in parallel.
For a more technical discussion, see http://forums.adafruit.com/viewtopic.ph ... 6&start=21
For a more technical discussion, see http://forums.adafruit.com/viewtopic.ph ... 6&start=21
Please be positive and constructive with your questions and comments.