I am in the process of building the monochron clock. The board fails the second beep test. The voltage still is at 5.07 as it was for the first test. I'm including a photo of the back of the board.
Monochron fails beep test
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88088
- Joined: Sat Feb 07, 2009 10:11 am
Re: Monochron fails beep test
Do you mean the test after the switch and indicator LED are installed?The board fails the second beep test.
Please post a photo showing the entire back of the board. And one of the front as well.
-
- Posts: 2
- Joined: Thu May 01, 2014 5:39 pm
Re: Monochron fails beep test
It was the second test after installing the speaker and before the LED is installed. I tried including an edge to edge photo but it was too large to post so I cropped it. The photo does have all the connections. I can try and post it in two sections. Here's a photo of the front of the board.
- adafruit_support_bill
- Posts: 88088
- Joined: Sat Feb 07, 2009 10:11 am
Re: Monochron fails beep test
OK. So it was the second test, but the first test involving a beep? You solder looks fine and everything is in the right place. I suspect you may have a processor that was not successfully flashed with the firmware. If you contact [email protected] with a link to this thread we can get a replacement out to you.It was the second test after installing the speaker and before the LED is installed.
Please be positive and constructive with your questions and comments.