Help with Manncorp T200 programming

[bmw330i]

Hey everyone,
I'm the proud owner of a barely used T200. I have only experience with a cheap T965 reflow that really doesn't do much right. My expectations for the T200 are that it can be programmed with help from the Internet.
Does anyone here have experience with this oven they can share? I'm going to be doing some u-blox module reflow, gyros, small ICs on fairly small 4-layer (i.e. 4cm x 6cm size) boards. Nothing big or fancy really.
-DC

[cellis]

Hi BMW,

If you still need help please call me in the office at Manncorp. 215-830-1200. I can try to get you the help you need.

Thanks

Chris Ellis

[bmw330i]

Thank you Chris for the offer. I got it figured out. Took some time but I'm finally making boards without burning them. Just a matter of tweaking a profile I found online to suit and some trial and error.

-David