Help with Manncorp T200 programming

Chat about pick and place machines, reflow ovens, assembly techniques and other SMT tips & trix

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
bmw330i
 
Posts: 51
Joined: Mon May 07, 2012 9:59 pm

Help with Manncorp T200 programming

Post by bmw330i »

Hey everyone,
I'm the proud owner of a barely used T200. I have only experience with a cheap T965 reflow that really doesn't do much right. My expectations for the T200 are that it can be programmed with help from the Internet.
Does anyone here have experience with this oven they can share? I'm going to be doing some u-blox module reflow, gyros, small ICs on fairly small 4-layer (i.e. 4cm x 6cm size) boards. Nothing big or fancy really.
-DC

cellis
 
Posts: 1
Joined: Wed Nov 18, 2009 11:53 am

Re: Help with Manncorp T200 programming

Post by cellis »

Hi BMW,

If you still need help please call me in the office at Manncorp. 215-830-1200. I can try to get you the help you need.

Thanks

Chris Ellis

bmw330i
 
Posts: 51
Joined: Mon May 07, 2012 9:59 pm

Re: Help with Manncorp T200 programming

Post by bmw330i »

Thank you Chris for the offer. I got it figured out. Took some time but I'm finally making boards without burning them. Just a matter of tweaking a profile I found online to suit and some trial and error.

-David

Locked
Please be positive and constructive with your questions and comments.

Return to “SMT (Surface Mount Tech)”