Hi, in the product description of the Extech EX330 you write:
... and on top of that, its been our daily-use multimeter for over 3 years. It's compact, has auto-off, tons of features and a temperature probe for checking thermal properties, soldering iron calibration and perhaps even a DIY reflow control.
Pls let me know which probe you are using with the ex 330. The delivered probe is good for temperatures up to 482 Fahrenheit only.
best regards
Arthur
Extech EX330 - soldering iron calibration
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88096
- Joined: Sat Feb 07, 2009 10:11 am
Re: Extech EX330 - soldering iron calibration
Any K-type thermocouple will work. These are good to 900F: https://www.adafruit.com/products/270
- a-9555
- Posts: 2
- Joined: Fri Feb 08, 2013 3:53 pm
Re: Extech EX330 - soldering iron calibration
and how to connect that wire with the ex330?
- adafruit_support_bill
- Posts: 88096
- Joined: Sat Feb 07, 2009 10:11 am
Re: Extech EX330 - soldering iron calibration
The supplied probe has screw terminals for attaching the thermocouple.
Please be positive and constructive with your questions and comments.