Please tell me the WiFi USB Microscope I bought for $200 is not really the piece of @# it seems to be.
The only instructions shipped with it were on a small disc - which is not usable with a mac or iPad or just about any tablet, unless you buy an external drive.
Once I found a machine that could read it, I found the PDF file with instructions (why cant Adafruit host this to make life easier for customers?)
which says you can attach to it by selecting the WiFi Network HOT and entering a specific numeric URL.... 10.10.1.1:8196
This brings up a 640x480 image that updates at an EXTREMELY low rate.
You have to position and focus using this high latency interface -- which is very hard to do.
I get about 1-2 fps out of this.
Please tell me there is something I am doing wrong - other than buying this.