Hi there,
I have managed to make my Wifi Shield work (both UNO R3 and Leonardo)
I have managed to make my 2.8 TFT Shield work (both UNO R3 and Leonardo)
I cannot for the life of me get both Wifi + 2.8 TFT to work together on either board (UNO R3 or Leo)
Advice? Anyone tried this? I have search hi and low, no dice.
Hardware.
Wifi Shield (authentic arduino one)
2.8 TFT (authentic adafruit one)
thanks in advace
Wifi Shield + 2.8 TFT Shield
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88093
- Joined: Sat Feb 07, 2009 10:11 am
Re: Wifi Shield + 2.8 TFT Shield
The TFT shield uses a LOT of pins, so there are likely some pin conflicts. Look up the pin utilization on the WiFi shield and compare that with what is used by the TFT. http://learn.adafruit.com/2-8-tft-touch-shield
Sometimes it is possible to re-map pins, but it usually involves some cut & jumper work on the board.
Sometimes it is possible to re-map pins, but it usually involves some cut & jumper work on the board.
- anchange
- Posts: 2
- Joined: Thu Feb 07, 2013 8:14 pm
Re: Wifi Shield + 2.8 TFT Shield
Hi 32teeth,
Did you find a solution to this? I'm trying to do the same thing. I've had some success but it's a little bit spotty...
Did you find a solution to this? I'm trying to do the same thing. I've had some success but it's a little bit spotty...
- 32teeth
- Posts: 13
- Joined: Mon Nov 14, 2011 2:35 pm
Re: Wifi Shield + 2.8 TFT Shield
can you share any of your code?anchange wrote:Hi 32teeth,
Did you find a solution to this? I'm trying to do the same thing. I've had some success but it's a little bit spotty...
Please be positive and constructive with your questions and comments.