I just purchased 4M of #306 digital RGB LEDs. I tested them with the basic test pattern provided by Adafruit. I get random lights to go on very very slowly but no pattern. I have a 1M strip that I tested on the Arduino with the same program and they work fine so I can conclude it is not the program or the Arduino. In looking at the strip there are bends in it that I had to straighten out, some areas look corroded and the wiring pattern is the opposite to the first batch I purchased. I am suspicious it is a bad strip. Support asked that I pose this on the forum. What are your thoughts?
Thank you.
China Blue
Digital RGB LEDs #306
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_mike
- Posts: 67485
- Joined: Thu Feb 11, 2010 2:51 pm
Re: Digital RGB LEDs #306
Could you post a photo of the areas that look corroded please? If there's damage we'll certainly replace them.
- chinablue
- Posts: 49
- Joined: Wed Jul 06, 2011 9:01 pm
Re: Digital RGB LEDs #306
Mike:
Sorry for the slow response, I was waiting for Adafruit to send a notice that I received a response and did not get it .
I have attached images. , , Thanks.
China Blue
Sorry for the slow response, I was waiting for Adafruit to send a notice that I received a response and did not get it .
I have attached images. , , Thanks.
China Blue
- chinablue
- Posts: 49
- Joined: Wed Jul 06, 2011 9:01 pm
Re: Digital RGB LEDs #306
Mike:
The Final image did not come through well. Here it is again. China Blue
The Final image did not come through well. Here it is again. China Blue
- adafruit_support_mike
- Posts: 67485
- Joined: Thu Feb 11, 2010 2:51 pm
Re: Digital RGB LEDs #306
I'm not sure what that is, but if you have three strips that work and one that doesn't, it's a hardware problem.
Send a note to [email protected] with a link to this thread and we'll get you another strip.
I apologize for the reply message not getting through to you.. I'll mention that to the web team.
Send a note to [email protected] with a link to this thread and we'll get you another strip.
I apologize for the reply message not getting through to you.. I'll mention that to the web team.
- chinablue
- Posts: 49
- Joined: Wed Jul 06, 2011 9:01 pm
Re: Digital RGB LEDs #306
Mike:
Thanks, I will send a note to support with the link.
Don't worry about the reply message not getting through. I suspect it might have been human error (chagrin).
China Blue
Thanks, I will send a note to support with the link.
Don't worry about the reply message not getting through. I suspect it might have been human error (chagrin).
China Blue
Please be positive and constructive with your questions and comments.