EL Tape won't work
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 1
- Joined: Thu Oct 10, 2013 9:33 pm
EL Tape won't work
I purchased the Electroluminescent (EL) Tape/Strip Starter Pack - 100cm - Blue and a Flowing effect wire. The wire works fine but the didn't light up when I connected it to the inverter it came with. I heard the inverter going so not too sure what's going on.
- adafruit_support_bill
- Posts: 88090
- Joined: Sat Feb 07, 2009 10:11 am
Re: EL Tape won't work
Make sure that the connectors are pushed in fully on the inverter. They might feel secure, but don't actually make contact until pushed fully down.
Please be positive and constructive with your questions and comments.