i recently purchased an EL starter kit. the wire comes with the connector already attached and covered with shrink tubing. the blue and red work. the green doesn't light. i've wiggled the connector, but i haven't taken it apart.
i was thinking i would return as defective, but was instructed to post to the forum.
suggestions?
-db
> Products
> ------------------------------------------------------
> 1 x High Brightness Green Electroluminescent (EL) Wire - 2.5 meters (High
> brightness, long life) [ID:407]
> 1 x High Brightness Red Electroluminescent (EL) Wire - 2.5 meters (High
> brightness, long life) [ID:403]
> 1 x EL wire starter pack - Blue 2.5 meter (8.2 ft)[ID:583]
EL wire not working
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_rick
- Posts: 35092
- Joined: Tue Mar 15, 2011 11:42 am
Re: EL wire not working
Please email [email protected] with a link to this thread for a replacement Green wire
Please be positive and constructive with your questions and comments.