Raspberry Pi footprints?

[osbock]

Hi,
The Wyolum gang (including myself) are working on a 'duino clone/plate for the Raspberry Pi(announcement here: http://baldwisdom.com/raspberry-pi-a-la-mode/)
We don't have a Pi in our hot little hands yet (sigh, ordered back in early march)
and the documentation on the elinux wiki seems inconsistent. When I scale the width of the Gerber png they have up to the specified width, the height doesn't match. Pin spacing seems ok though..
Does anyone have a footprint drawing they can share? We're most concerned about the spacing between the GPIO header and the JTAG header. We're planning on passing through the JTAG both for future debugging and for stability (female header on the bottom of our "plate")
We prefer KiCad, but anything (even a properly scaled jpeg) would do. (scan your pi anyone?)
Thanks,
Kevin

[kphannan]

I'm looking for the same thing. I am trying to lay out a CAN interface board and need the overall dimensions and placement of the GPIO connector. All the rest of the connectors would be great, but not needed immediately.