MrToasty wrote:Just received my Pi yesterday and assembled the case around it this morning. I ran into the exact same problem as tadpole. I was very careful to not stress the claws when assembling but two of the upper claws both snapped off. Now the wall on the power end is flapping in the breeze.
sirsyko wrote:I'm wondering if the choice for Acrylic for this case was a good one. My case slid off the tv stand about 6 inches onto the shelf below and two of the clasps popped off. Fortunately they were at diagonal from eachother, thus it remains together (as long as I hold it properly as I connect/disconnect cables). I can see how easy it would be for these things to pop off when trying to put it together.
Users browsing this forum: No registered users and 4 guests