7in TFT Display - "Fuzzy" video

[bprewit]

Using the 7in TFT display with the raspi & the adafruit linux distro the output is too fuzzy to read .. any suggestions?

[adafruit_support_bill]

It could be a problem in the display, the raspi output or the cable. The best way to figure out which is to start swapping components. Try a different cable if you have one. Also try a different video source with the display or a different display with the raspi.

[tetravalence]

Resolution might also be the problem. Try setting your resolution in config.txt to 480 x 234.

[adafruit]

thats a good suggestions, tetra!

[tbitson]

Is this the framebuffer_width and framebuffer_height values?

[zulucat]

Is this the framebuffer_width and framebuffer_height values?

Wow, what a great forum! I was having the same "fuzzy" problem & setting framebuffer width & height fixed it for me. I also added the line

sdtv_aspect=3

to configuration.txt. It sets the aspect ration to 16:9.

for more info see http://elinux.org/RPi_config.txt

[bprewit]

After trying the display with a different board and cable, and using the recommended settings (sdtv_aspect=3, framebuffer_width=480, framebuffer_height=234), text on the monitor is still unreadable.

Any other suggestions?

[adafruit_support_bill]

Can you post a photo of it?

[bprewit]

Here's a couple .. the display actually looks better in the pictures than it does live ..

IMG-20121014-00023.jpg (847.87 KiB) Viewed 727 times

IMG-20121014-00021.jpg (705.71 KiB) Viewed 727 times

[adafruit_support_bill]

Contact support@adafruit.com with a link to this thread and ask for a replacement.

[skaxxo]

i have the same issue... any suggestions to improve this problem?