I was wondering if there are ways other than using a SPI interface to add this mic to the board since RPi does not support analog inputs.
thank you very much.
Is it possible to put MAX4466 from ada on RPi??
Moderators: adafruit_support_bill, adafruit
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
-
- Posts: 3
- Joined: Fri Dec 28, 2012 6:28 pm
-
- Posts: 26
- Joined: Sun Feb 12, 2012 12:17 pm
Re: Is it possible to put MAX4466 from ada on RPi??
Take a look at (MCP3008 - 8-Channel 10-Bit ADC With SPI Interface - ID: 856)
-
- Posts: 3
- Joined: Fri Dec 28, 2012 6:28 pm
Re: Is it possible to put MAX4466 from ada on RPi??
I was thinking of that. following that tut, but that was only for an analog control. so the plan is basically read in and use that to convert to digital? and thereafter use other driver programs to convert into audios?
-
- Posts: 3
- Joined: Fri Dec 28, 2012 6:28 pm
Re: Is it possible to put MAX4466 from ada on RPi??
Would that be a good approach or any other ways? i'm totally new into this field. needed a lot suggestions. I'm a total noob
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/