Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/

Small-Size Perma Proto Push-Button Question

by punkzter on Mon Jan 14, 2013 1:54 pm

Hi,

I want to make a project that uses a number of push buttons. Ideally, I would use as small a board as possible, which is why the small perma board is appealing. However, I want to use the push buttons, and they take 4 slots.

So, my question, is whether or not I can just snip pins that I'm not using?

Or, if I don't activate a GPIO pin in python, does it matter if a signal goes to it?

Thanks,
Brad
punkzter
 
Posts: 7
Joined: Mon Aug 23, 2010 7:00 pm

Re: Small-Size Perma Proto Push-Button Question

by adafruit_support_bill on Mon Jan 14, 2013 4:54 pm

You can snip pins you are not using. But if you don't read from those GPIO pins on the Pi it doesn't matter.
User avatar
adafruit_support_bill
 
Posts: 28118
Joined: Sat Feb 07, 2009 9:11 am