Screen 910 questions

Moderators: adafruit_support_bill, adafruit

Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Locked
User avatar
doctorwho8
 
Posts: 160
Joined: Sat Aug 01, 2009 10:24 pm

Screen 910 questions

Post by doctorwho8 »

Hello!
I bought earlier a 910 screen, that's http://www.adafruit.com/products/910 .

The power input guide lines say 4 volts to 15 volts, as here "Power with 4.5-15VDC only into onboard buck converter". And as it happens I got it to work briefly being powered by 5 volts coming from a power supply other then the one that came with my Raspberry PI starter Kit. I believe I saw the screen light up and show the video coming into it. I then decided to swap out the plug in power supply and try a battery pack, especially since I had hoped to build a portable system concerning my system.

I stopped when I thought I smelled smoke and felt the board. It felt warm right by the coils and the regulator.
And I know that's not normal.

Any suggestions?

User avatar
doctorwho8
 
Posts: 160
Joined: Sat Aug 01, 2009 10:24 pm

Re: Screen 910 questions

Post by doctorwho8 »

Hello!
While waiting for all of you to respond to my post update:[See below]
I decided to try again. This time trying a variety of 3 selected 1.5v cells in series, and then a battery pack that's normally sold for people to get their cells work in an almost any situation. Sadly I felt the same things happen that happened before. There was no video and no flicker from the backlights. I believe something went horribly wrong and I therefore believe I need an RMA to send the poor thing back for replacement. Screen is okay. It's the driver board that's bad.
doctorwho8 wrote:Hello!
I bought earlier a 910 screen, that's http://www.adafruit.com/products/910 .

The power input guide lines say 4 volts to 15 volts, as here "Power with 4.5-15VDC only into onboard buck converter". And as it happens I got it to work briefly being powered by 5 volts coming from a power supply other then the one that came with my Raspberry PI starter Kit. I believe I saw the screen light up and show the video coming into it. I then decided to swap out the plug in power supply and try a battery pack, especially since I had hoped to build a portable system concerning my system.

I stopped when I thought I smelled smoke and felt the board. It felt warm right by the coils and the regulator.
And I know that's not normal.

Any suggestions?

User avatar
adafruit_support_bill
 
Posts: 88089
Joined: Sat Feb 07, 2009 10:11 am

Re: Screen 910 questions

Post by adafruit_support_bill »

Contact [email protected] with a link to this thread to arrange for a replacement.

Locked
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/

Return to “Adafruit Raspberry Pi® accessories”