is it possible to use the pinout from
http://www.adafruit.com/products/1115
to power/drive
http://www.adafruit.com/products/498
so that would be using the piplate to drive a 4x20 lcd instead of the regular 2x16 i know i would most likely be losing the ability to use the buttons and would have to do an interesting header stack in order to clear the i2c controller for the board... does anyone know if its compatible??
piplate + 4x20 lcd
Moderators: adafruit_support_bill, adafruit
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
- adafruit_support_mike
- Posts: 67446
- Joined: Thu Feb 11, 2010 2:51 pm
Re: piplate + 4x20 lcd
The buses and signals are the same, yes: http://learn.adafruit.com/character-lcd ... racter-lcd
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/